specification order no. safety model no. dc voltage note.2 rated current current range rated power (max.) ripple & noise (max.) note.3 output voltage range note.9 frequency range power factor (typ.) efficiency (typ.) ac current (typ.) input environment inrush current (max.) leakage current(max.) safety standards safety & emc (note. 7) working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing protection gs90a15-p1m GS90A12-P1M gs90a19-p1m gs90a24-p1m gs90a48-p1m 15v 12v gs90a15 gs90a12 19v gs90a19 24v gs90a24 48v gs90a48 100mvp-p 80mvp-p 150mvp-p 180mvp-p 240mvp-p voltage tolerance note.4 line regulation note.5 load regulation note.6 5.0% 5.0% 4.0% 3.0% 2.0% 1.0% 1.0% 1.0% 1.0% 1.0% 5.0% 5.0% 4.0% 3.0% 2.0% 90 ~ 264vac 127 ~ 370vdc 47 ~ 63hz pf>0.91 / 230vac pf>0.95 / 115vac at full load 89% 88% 89% 89.5% 91% 2a / 115vac 1a / 230vac 70a / 230vac 1ma / 240vac withstand voltage isolation resistance i/p-o/p: 3kvac i/p-fg:1.5kvac o/p-fg:0.5kvac i/p-o/p, i/p-fg, o/p-fg / 25 / 70% rh :100m ohms / 500vdc 348.7khrs min. mil-hdbk-217f(25 ) -30 ~ +50 (refer to "derating curve") 20% ~ 90% rh non-condensing -40 ~ +85 , 10 ~ 95% rh 0.03% / (0~50 ) 10 ~ 500hz, 2g 10min./1cycle, period for 60min. each along x, y, z axes 145*60*32mm (l*w*h) 0.45kg; 30pcs/14.05kg/1cuft connector plug cable standard type for stock ther type available by customer requested p1m: 2.5 * 5.5 * 11mm, tuning fork type, center positive ; o see page 2 ther type available by customer requested ; o 1. all parameters are specified at 230vac input, rated load, 25 70% rh ambie nt. 2. dc voltage: the output voltage set at point measure by plug terminal & 50% loa d. 3. ripple & noise are measured at 20mhz by using a 12" twisted pair terminated wi th a 0.1uf & 47uf capacitor. 4. tolerance: includes set up tolerance, line regulation, load regula tion. 5. line regulation is measured from low line to high line at rated load. 6. load regulation is measured from 10% to 100% rated load 7. the power supply is considered as an independent unit, but the final equip ment still need to re-confirm that the whole system complies with the emc directives. 8. length of set up time is measured at first cold start. turning on/off the powe r supply may lead to increase of the set up time. 9. derating may be needed under low input voltages. pleas check the derati ng curve for more details. 90w ac-dc single output desktop g s 9 0 s e r i e s features : compliance to en61000-4-2,3,4,5,6,8,11, light industry level, c riteria a overload over voltage 110 ~ 150% rated output power protection type : hiccup mode, recovers automatically after fault con dition is removed 105 ~ 135% rated output voltage 6a 6.67a 4.74a 3.75a 1.87a 0 ~ 6a 0 ~ 6.67a 0 ~ 4.74a 0 ~ 3.75a 0 ~ 1.87a 90w 80w 90w 90w 90w protection type : shut down o/p voltage, re-power on to recover ul60950-1, tuv en60950-1, bsmi cns14336, approved j60950-1(except for 48v) compliance to en55022 , fcc part 15 / cispr22 class b class b en61000-3-2,3, , cns13438 class b, gb17625.1 universal ac input / full range 3 pole ac inlet iec320-c14 protections: short circuit / overload / over voltage / over temperature fully enclosed plastic case approvals: ul / cul / tuv / bsmi / cb / fcc / ce class power ( with earth pin) pass lps led indicator for power on no load power consumption<0.5w meet eisa 2007(energy independence and security act) 2 years warranty built-in active pfc function, pf>0.91 tuv rheinland product safety geprufresicherheit file name:gs90-spec 2011-06-15 setup, rise time note.8 hold up time (typ.) 1000ms, 20ms / 230vac 1000ms, 20ms / 115vac at full load 20ms / 230vac 20ms / 115vac at full load over temperature rth30 > 100 protection type : shut down o/p voltage, re-power on to recover (except for 48v) emc immunity emc emission
70 10mm 11 0.5mm mechanical specification file name:gs90-spec 2011-06-15 ambient temperature ( ) load (%) 0 -30 20 10 30 40 20 40 50 80 60 100 60 50 70 input voltage (vac) 60hz 90 100 95 120 110 160 140 200 180 240 220 264 load (%) ta=25 90 100 80 70 60 50 40 (horizontal) derating curve static characteristics 145 32 60 power led plug assignment standard plug: p1m id 2.5 x od 5.5 c"+" p/n output p1m center + g s 9 0 s e r i e s 90w ac-dc single output desktop ul1185 14awg 1000 50mm for 12v ~ 15v ul1185 16awg 1200 50mm for 19 ~ 48v case no. 978a unit:mm
|